Analysis (Reports); Recording - LeCroy USB Protocol Suite Advisor T3 User Manual

Chapter 4: Software Overview

4.3.4 Analysis (Reports)

4.3.5 Recording

80
File Information Report
See "File Information" on page 177.
Timing and Bus Usage Calculations
See "Timing Calculations" on page
180.
Data View
See "Detail View" on page 205.
Link Tracker
See "Link Tracker (3.0)" on page
193.
Open the Navigator bar
See "Using the Trace Navigator" on
page 198.
Show USB3 Link State Timing View.
See "USB3 Link State Timing
View" on page 207.
Run Verification Scripts.
See "Running Verification Scripts" on
page 212.
Superspeed (USB 3.0) receiver terminations of Analyzer:
M3i: If both Analyzer ports are set to Auto in Recording Options, this button
is dimmed. If either port is set to Manual, this button can apply or
remove USB 3.0 termination.
M3: This button is always enabled, and Auto mode is not supported.
Start Recording
Stop Recording
Momentary VBus Disconnect (Voyager M3i Only)
Causes the VBus power between the Host and the Device connected through
the Analyzer A and B USB ports to be broken for 1 second, simulating a
unplug-plugin cycle. This is the recommended method of creating plug-in
scenarios.
Note: When Disconnect is done during recording, it may cause capturing of IPS
(undecodable symbols) and false triggering of CRC triggers, because packets
will be abruptly stopped in the middle of a symbol stream.
USB Protocol Suite User Manual
Error Report
See "Error Summary" on page 179.
Traffic Summary
See "Traffic Summary" on page 184.
Bus Utilization
See "Bus Utilization" on page 186.
Spec View
See "Spec View (3.0)" on page 206.
Detail View
See "Detail View" on page 205.
Show USB3 LTSSM View
See "USB3 LTSSM View" on
page 209.
Show Power Tracker.
(Power captures are supported only
on Voyager M3i.)
See "Power Tracker" on page 210.
Manual Trigger
Repeat Upload
LeCroy Corporation