Setting Up The Analyzer - Ethernet Connection - LeCroy USB Protocol Suite Advisor T3 User Manual

Chapter 3: Installation
Step 6 Follow the Microsoft
Step 7 Click Finish when you see the message that says "Windows has finished
Step 8 Check Analyzer setup in the "Application Startup" section (See "Application
Warning!

3.3 Setting Up the Analyzer - Ethernet Connection

To set up an Analyzer using an Ethernet connection:
Step 1 Connect the provided AC power cord to the rear of the Voyager M3 and to a
Note:
Step 2 Insert the Installation CD.
Step 3 To use a DHCP network, make sure that the PC connects to a DHCP network,
Step 4 Turn on the power switch.
Note:
Step 5 Complete Analyzer setup in the "Application Startup" section (See "Application
Warning!
52
®
Windows
automatic installation of the Analyzer as a USB device on your analyzing PC (the
required USB files are included on the Installation CD).
installing the software that your new hardware requires" and the driver files have
been installed in your PC.
Startup" on page 56).
Do not change from USB to Ethernet, or back, without power cycling the
Analyzer.
100-volt to 240-volt, 50-Hz to 60-Hz, 100-W power outlet.
The Analyzer is capable of supporting supply voltages between 100 volts
and 240 volts, 50 Hz or 60 Hz, thus supporting all supply voltages around the
world.
then connect the Ethernet port on the Analyzer to the DHCP network.
Note: If the DHCP network uses a Firewall, you must set the Firewall to allow the
Analyzer device on the network.
Note: Direct connection from the Ethernet port on the PC to the Ethernet port on
the Analyzer is supported in this release. See "IP Settings (Voyager only)" on
page 58.
At power-on, the Analyzer initializes itself in approximately ten seconds and
performs an exhaustive self-diagnostic that lasts about five seconds. If the
diagnostics fail, call LeCroy.
Startup" on page 56).
Do not change from USB to Ethernet, or back, without power cycling the
Analyzer.
USB Protocol Suite User Manual
®
on-screen Plug-and-Play instructions for the
LeCroy Corporation