Table of Contents
Advertisement
71X Series
Calibration Manual
4. Disconnect the test leads.
Resistance Source Verification
1. Using four test leads, connect the four jacks of Fluke 8508A (Ω Sense 'Hi & Lo' and
2. On the Fluke 8508A , select four-wire ohms measurement and up-range to the 1 kΩ
3. Push the
Using the large (,), and small (,), scroll keys, source the resistance settings
in Table 35, verifying the readings on the Fluke 8508A display:
Keypad Test
1. Push and hold the large to source 950.0 Ω.
2. Push and hold the small
3. Push and hold the small
4. Disconnect all test leads from the 712 Calibrator and push the
Display Verification
1. Push and hold the
2. Check to see that all segments of the LCD are displayed.
3. Turn the 712 off.
The 712 verification test is complete.
28
sales@GlobalTestSupply.com
Input 'Hi & Lo') to the two middle jacks of the 712 Calibrator (black to black; red to
red). This puts the Fluke 8508A in a 4-wire configuration.
range. Use the 1 kΩ range for the first test point, and use the 10 kΩ range for the last
two test points. Correct ranging is important in supplying the correct excitation
current back into the 712 Calibrator. Otherwise the specifications may change, or the
measurements may be incorrect.
key on the 712 Calibrator so that the display indicates:
OUTPUT
Table 35. 712 Resistance Source Verification
Fluke 712
207.5 Ω
950.0 Ω
2350.0 Ω
changes in 0.1 increments, then changes in 1.0 increments, then in 10.0 increments.
changes in 0.1 decrements, then changes in 1.0 decrements, then in 10.0 decrements.
calibrator off.
key and then turn the 712 back on by pressing and releasing
the green key. This locks the 712 in a mode where all display segments are on. All
segments will stay on until the
Fluke-Direct
Fluke 8508A
.2074 to .2076 kΩ
.9495 to .9505 kΩ
2.349 to 2.351 kΩ
scroll key. Verify the numbers scrolling on the display
scroll key. Verify the numbers scrolling on the display
key is released.
key to turn the
.com
1.888.610.7664
Advertisement
Table of Contents
