Page 2
LIMITED WARRANTY AND LIMITATION OF LIABILITY This Fluke product will be free from defects in material and workmanship for three years from the date of purchase. This warranty does not cover fuses, disposable batteries, or damage from accident, neglect, misuse, alteration, contamination, or abnormal conditions of operation or handling.
Table of Contents Title Page Introduction ........................1 How to Contact Fluke ..................... 1 Standard Equipment....................... 2 Safety Information ......................2 Hazard Location Information/Approvals ..............3 Special Conditions for Safe Use ................3 Symbols ........................4 Display and Buttons ....................... 5 Operation ........................
Page 4
RS-232 Interface ....................... 11 Specifications ........................ 12 Available Input Ranges ..................... 12 Accuracy ........................12 Media Compatibility ....................12 Environmental ......................12 Mechanical Specifications ..................13 PI Ranges and Resolution ..................14 MyFlukeStore 1.877.766.5412 www. .com Shop for Fluke products online at:...
List of Tables Table Title Page Symbols ..........................4 Display and Buttons ......................5 MyFlukeStore 1.877.766.5412 www. .com Shop for Fluke products online at:...
Page 6
700G Series Users Manual MyFlukeStore 1.877.766.5412 www. .com Shop for Fluke products online at:...
List of Figures Figure Title Page The Product ........................... 5 Change the Batteries ......................10 MyFlukeStore 1.877.766.5412 www. .com Shop for Fluke products online at:...
Page 8
700G Series Users Manual MyFlukeStore 1.877.766.5412 www. .com Shop for Fluke products online at:...
Introduction How to Contact Fluke The 700G Series Pressure Gauges (the Product) are To contact Fluke, call one of the following telephone high-accuracy digital pressure test gauges. Accurate to numbers: 0.05 % FS, the Products can be used as a calibration...
Product. Replace the batteries when the low battery indicator ()shows to prevent incorrect measurements. Do not use and disable the Product if it is damaged. MyFlukeStore 1.877.766.5412 www. .com Shop for Fluke products online at:...
These areas are also any damage that can cause a safety concern. If referred to as hazardous locations, see NFPA 70 Article necessary, return the Product for evaluation to Fluke. 500. Refer to the How to Contact Fluke section.
Conforms to relevant North American Hazardous voltage. Risk of electrical shock. Safety Standards. Do not dispose of this product as Pressure unsorted municipal waste. Go to Fluke’s website for recycling information. Conforms to relevant Australian standards. Conforms to ATEX requirements MyFlukeStore 1.877.766.5412...
To clear the MIN MAX memory values, push and hold for 2 seconds until CLr is shown. In Configure Mode, push () to move backward through the menus. gsn001.eps Figure 1. The Product MyFlukeStore 1.877.766.5412 www. .com Shop for Fluke products online at:...
Pressure now shows in the chosen engineering units. See the Specifications section for a list of available engineering units. See the Supervisory Mode section for instructions to set up custom units. MyFlukeStore 1.877.766.5412 www. .com Shop for Fluke products online at:...
Selections are “on” and “off” . Damping smooths of the tare position. This is done to make sure that even readings from pulsating pressure sources. with a “0” reading pressure is being applied to the gauge. MyFlukeStore 1.877.766.5412 www. .com Shop for Fluke products online at:...
1. The password is factory set and cannot be changed. Push . From this point each parameter can be locked or unlocked. Push and to select UnLOC or LOC for MyFlukeStore 1.877.766.5412 www. .com Shop for Fluke products online at:...
How to Change the Batteries section. is not used for an extended period. Be sure that the battery polarity is correct to prevent battery leakage. Have an approved technician repair the Product. MyFlukeStore 1.877.766.5412 www. .com Shop for Fluke products online at:...
Use a Phillips screwdriver to loosen the captive screw on the battery door. Remove the battery door. Replace the three AA batteries. Install the battery door again. Tighten the captive screw. gsn002.eps Figure 2. Change the Batteries MyFlukeStore 1.877.766.5412 www. .com Shop for Fluke products online at:...
700G/TRACK Software. For specifications on the interface, see the Specifications section. XWWarning To prevent possible electrical shock, fire, or personal injury, do not use the RS-232 interface in hazardous areas. MyFlukeStore 1.877.766.5412 www. .com Shop for Fluke products online at:...
20-Segment bar graph, 0 to 100 % Power Battery ................... three size AA alkaline batteries Battery Life ................1,500 hours without backlight (continuous on), 2,000 hours at slow sample rate MyFlukeStore 1.877.766.5412 www. .com Shop for Fluke products online at:...