715 Verification (Earlier Than V2.0); Dc Voltage Source Verification; Dc Current Source Verification; Dc Voltage Source Verification (0.000 To 10.000 V) - Fluke 71X Series Calibration Manual

715 Verification (Earlier than V2.0)

DC Voltage Source Verification

1. On the 715 Calibrator turn the green  key on.
2. Push the  and the  key so that the display indicates:
3. Connect test leads from the Fluke 8508A input HI & LO jacks to the voltage jacks on
4. Using the large  scroll button of the 715 Calibrator, push to step to the voltages in
5. Push the  key on the 715 Calibrator. Display should change to:
6. Using the large  key scroll button of the 715 Calibrator, push to step to the

DC Current Source Verification

1. Disconnect the Fluke 8508A. Push the key on the 715 Calibrator. The display
2. Connect test leads from the 715 Calibrator's mA output jacks (black to V jack and red
3. Set the Fluke 8508A function to [
sales@GlobalTestSupply.com
OUTPUT 0.000 V
the 715 Calibrator (black to COM and red to V).
Table 50, verifying the output on the Fluke 8508A:
Table 50. 715 DC Voltage Source Verification (0.000 to 10.000 V)
Fluke 715
0.000 V
5.000 V
10.000 V
OUTPUT 0.00 mV
voltages in Table 51, verifying the output on the Fluke 8508A.
Table 51. 715 DC Voltage Source Verification (0.00 to 100.00 V)
Fluke 715
0.00 mV
50.00 mV
100.00 mV
should change to:
OUTPUT 0.000 mA
to +LOOP jack) to the Fluke 8508A input mA jacks (black to I- and red to I+).
the 715 Calibrator, push to step to the current outputs in
Table 52, verifying the readings on the Fluke 8508A.
Table 52. 715 DC Current Source Verification
Fluke 715
4.000 mA
12.000 mA
24.000 mA
Fluke-Direct
Fluke 8508A
-0.002 V to + 0.002 V
4.997 V to 5.003 V
9.996 V to 10.004 V
Fluke 8508A
-0.02 mV to + 0.02 mV
49.97 mV to 50.03 mV
99.96 mV to 100.04 mV
]. Using the large  scroll button of
DC CURRENT
Fluke 8508A
3.9972 mA to 4.0028 mA
11.9956 mA to 12.0044 mA
23.9932 mA to 24.0068 mA
Process Calibrators
.com
1.888.610.7664
Verification
35