Sun Microsystems Ultra 10 Getting Started Manual page 49

7. At the two nearest corners of the card, push the card straight into the connector
until the card is fully seated.
8. Using a No. 2 Phillips screwdriver, replace the screw securing the card bracket tab
to the system unit chassis.
9. Continue with "Finishing the Installation" on page en-35.
Finishing the Installation
1. Reconnect the system power cord.
2. Remove the antistatic wrist strap from the chassis.
3. Replace the cover.
4. Reconnect the monitor cable and any other peripheral cables to the system.
5. To power on the system, see "Powering On the System" on page en-4.
en-35