Drain Connections, Steam Supply And Condensate Connections; Ventilation Guidelines - Champion E Series Installation/Operation With Service Replacement Parts

Installation
Drain Connections
1. The 1-1/2" drain line was removed and packed inside the dishwasher prior to shipping. Install the drain
line once the dishwasher has been placed in its final location.
2. Connect the 1-1/2" NPT drain line above a drain sink or to a 1-1/2" or larger drain line connection.
3. Observe all local plumbing and sanitary codes when installing.
Steam Supply and Condensate Connections
1. Check the steam pressure requirements prior to connecting the steam supply lines.
The high pressure steam supply is 15-30 PSI/103-201 kPa.
The steam supply line must be a 1-1/4" NPT line with a 3/4" NPT condensate return.
2. Low pressure steam supply is 7-14 PSI/48.2-96.5 kPa.
The steam supply line must be a 2" NPT line with a 1" NPT condensate return.
3. Connect a steam supply line the same size or larger to the dishwasher at the steam supply strainer
located at the unload end of the dishwasher.
4. Condensate lines must be gravity drain with no back pressure. A condensate lift pump must be
installed if the condensate flow is above the finished floor.
Ventilation Connections
1. DO NOT VENT THE DISHWASHER INTO WALLS, CEILINGS OR ENCLOSED PLACES.
2. Vent stacks with adjustable dampers are supplied with the dishwasher to connect house vent.
3. Connect stainless steel water-tight duct inside the 4" x 16"/106mm x 407mm vent stacks
supplied with the dishwasher.
4. A minimum of 6 air changes per hour of kitchen is recommended

Ventilation Guidelines:

Dishwasher without a prewash tank option:
Load end- 200 CFM @ 1/4" SP/ 95 Liters/second
Unload end- 400 CFM @ 1/4" SP/ 189 Liters/second
Dishwasher with a Prewash tank option:
Load end- 150 CFM @ 1/4" SP/ 95 Liters/second
Unload end- 400 CFM @ 1/4" SP/ 189 Liters/second
Dishwashers with more than two tanks:
Load end- 200 CFM @ 1/4" SP/ 95 Liters/second
Unload end- 400 CFM @ 1/4" SP/ 189 Liters/second
4