Installation Checklist - Champion E Series Installation/Operation With Service Replacement Parts

Rack conveyor dishwashers
Table of Contents

Advertisement

Installation
Check list
1. Remove white protective film from the dishwasher exterior.
2. Install lower panels to the dishwasher.
3. Remove any foreign material from inside of the machine.
4. Check that the chemical supplies (supplied by others) are full.
5. Check to ensure the dishwasher drains are closed.
6. Install scrap screens, baskets and spray arms.
7. Turn main utilities to the dishwasher ON. (Power, water, steam if applicable).
8. Make sure doors are closed.
9. Turn dishwasher power switch ON. The tanks fill with water and the tank and booster
heat will come on.
NOTE:
The dishwasher will not start if the tanks are not full of water. If the dishwasher fills for
more than 20 minutes, the dishwasher will shut down and the green indicator light will
flash. Check the drain valves and make sure they are fully closed, then push the power
switch OFF and back ON and push the Green Start button to resume operation.
10. Check the digital tank water temperature gauges to ensure they indicate the proper
levels. The final rinse gauge displays OFF when the final rinse is not running.
11. Check for leaks.
12. Push the START button.
13. Insert an empty dish rack into the load end of the dishwasher.
The pumps and conveyor will run.
14. Carefully, open each dishwasher door to make sure the safety switch stops the
conveyor and pumps.
15. Restart the dishwasher by pressing the START button.
16. Allow the dish rack to travel to the unload end of the dishwasher. The final rinse
will run.
17. Allow the rack to exit the dishwasher. The dishwasher pumps and conveyor should
stop when the rack exits the dishwasher.
18. Push the Stop button when the machine is running and the dishwasher should stop.
19. Push the START button, insert a dish rack into the load end of the machine and the
pumps and conveyor should start.
20. Push the dishwasher Power Switch OFF. The dishwasher should shut down.
21. Drain the dishwasher and check that floor drains can handle the water volume leaving
the dishwasher.
NOTE:
Opening a door will stop the pumps and drive. If the door is closed within 5 minutes the
machine will resume operation where it left off. After 5 minutes the START switch must
be pressed and a dish rack inserted into the machine for normal operation.
18

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents