E!Cockpit; Figure 18: Setting Options In Wago-I/O-Check; Table 30: Setting Options Per Channel - WAGO 750-439 Manual

46 Commissioning

Figure 18: Setting Options in WAGO-I/O-CHECK

Table 30: Setting Options per Channel

Parameter
Input / Diagnostics
Sensor type IN
Diagnosis lock IN
*)
for NO only
**)
for NC only
Also the channel designation (default "Channel 1" ... "Channel 8") can be edited.
The respective designations are displayed in the navigation tree of WAGO-I/O-
CHECK and can be saved in the node file of WAGO-I/O-CHECK.
7.2

e!COCKPIT

The I/O-Modul 750-439 is supported by the e!COCKPIT commissioning tool, see
the "2759-0101 e!COCKPIT" manual, Section "Operating" > ... > "Performing a
Systematic Input/Output Test (WAGO-I/O-CHECK)".
Manual
Version 1.3.0, valid from HW Version 03, SW Version 03
Possible values
*)
Contact closed
**)
Contact open
*)
Contact open
**)
Contact closed
Short circuit
Wire break
Normally closed (NC)
Normally open (NO)


WAGO-I/O-SYSTEM 750
750-439 8DI NAMUR Ex i
Description
Status of the respective digital
input.
The texts displayed depend on
the respective sensor type
(NO or NC) of the channel or
on the fault status (short circuit
or wire break).
Normally open (NO):
DO.Bit[x] = 0
Normally closed (NC):
DO.Bit[x] = 1
Diagnostic block
enabled: D1.Bit[x] = 1
Diagnostic block disabled:
D1.Bit[x] = 0