Commissioning; Wago-I/O-Check; Figure 17: Rename I/O Module - WAGO 750-439 Manual

WAGO-I/O-SYSTEM 750
750-439 8DI NAMUR Ex i
7

Commissioning

7.1

WAGO-I/O-CHECK

The I/O Module 750-439 is supported by the WAGO-I/O-CHECK commissioning
tool staring with version 03.21.01(01).
After the node has been identified, the process values, the process values in
"Monitor Mode" or "Control Mode" are first displayed using the generic inputs
"750-4xx, 16DI / 16DO".
Rename the I/O module by marking it in the corresponding dialog and confirming
your selection by clicking the [OK] button.

Figure 17: Rename I/O Module

As soon as you have renamed the I/O module, the display of the I/O module is
adjusted. The correct view including the display elements is shown and the
diagnostics (short circuit / wire break) are interpreted.
Version 1.3.0, valid from HW Version 03, SW Version 03
Commissioning 45
Manual