Install the UltraGlide Wiring
Wiring Connections
For wiring connections made outside the cab, apply dielectric silicone grease (P/N 222-0000-006) generously
on both the male and female ends of the connectors. Application of the grease will prevent corrosion to the
pins and wires.
Install the AutoBoom Node
PowerGlide Plus AutoBoom Node Installed
FIGURE 9.
Mount the AutoBoom node (P/N 063-0130-013) to the machine's cross beam within close proximity to the
1.
AutoBoom valve.
Insert the large, rectangular node connectors on the AutoBoom harness cable (P/N 115-0230-045) into the
2.
correct ports of the AutoBoom valve.
Tighten the bolts on the node connectors to secure the connections.
3.
Manual No. 016-0230-013
CAUTION
Always connect the power cable as the last
step in the wiring process and verify that the
power leads are connected with the correct
polarity. Reversing power leads can cause
severe damage to the equipment.
UltraGlide
49