Install The Gauge Wheels; Gauge Wheel Mounting Locations; Mount The Gauge Wheels - Raven AutoBoom Installation Manual

Install the Gauge Wheels

Gauge Wheel Mounting Locations

Wheel mounting locations may be influenced by the boom configuration. Determine the appropriate location
for mounting the wheels on the boom, ensuring the wheels will not interfere with or be damaged while folding
or unfolding the booms. The wheels should be mounted outside of the boom fold, but inside the boom
breakaway.

Mount the Gauge Wheels

Note:
The appearance of the wheel axles may vary, depending on the wheel axle kit that was ordered.
Gauge Wheel Installed (Booms Folded)
FIGURE 5.
Remove the nuts from the right wheel axle).
1.
Place the wheel (P/N 322-0131-008) on the right wheel axle.
2.
Reinstall the lug nuts on the wheel axle to secure the wheel.
3.
Mount the right receiver bracket (P/N 116-0159-592) to the front of the right boom using four 1-9/16" W x 2-
4.
1/2" L x 3/8" thread U-bolts (P/N 107-0171-611) and eight 3/8"-16 zinc flanged lock nuts (P/N 312-1001-
164).
Insert the right wheel axle into the mounting bracket, positioning it so that the bottom of the wheel touches
5.
the ground (or nearly so) and the wheel faces away from the machine.
Secure the gauge wheel assembly in the wheel mounting bracket by installing two 1/2"-13 x 1-1/2" SS hex
6.
bolts (P/N 311-0058-186) and two 1/2" zinc hex nuts (P/N 312-1001-043).
Repeat the steps above to install the left wheel.
7.
Manual No. 016-0230-013
WARNING
The machine must remain stationary and
switched off, with the booms unfolded and
supported, during installation or maintenance.
PowerGlide
15