Table of Contents
Advertisement
1. Install each Tail Light Mount on the rear frame tube, approximately 35" from the center of the
frame. Secure mounts with 5/8-11 U-Bolts and Locknuts. See page 21B.
2. Install the Light Module on top of the Module Bracket Weldment using two 1/4-20 X 1-1/2 Screws
and Locknuts. See page 21B.
3. Attach the 7 pin harness to the Light Module. Route the harness along the frame and drawbar
with the hydraulic hoses. See page 21C.
4. Layout the LED Lamp Harness. Note that the cords are marked "Left" and "Right".
Attach the harness to the Light Module.
5. Route the left 3 plug cord along the left side of the frame center tube, across the rear frame
tube, then under and through the Left Tail Light Mount.
6.
Route the right 3 plug cord along the right side of the front frame tube and along the inside
of the inner frame tube, then under and through the Right Tail Light Mount.
7. Route the remaining left and right 2 plug cords along the left and right front frame tube. Route a
2 plug cord end into the bottom of each Lamp Bracket until the end sticks out the top. See page
21C.
8. Plug a 2 plug harness end into each Amber LED Lamp. Attach Amber LED Lamp to the light
bracket with 1/4-20 X 1-1/2 Screws and Locknuts. Attach the left Lamp Bracket to the back of
the front frame tube and the right Lamp Bracket to the front of the front frame tube using 1/2-13
U-Bolts, Flat Washers and Locknuts. See page 21C.
9. Plug a 3 plug harness end into each Red LED Lamp. With the lens facing rearward, install a Red
LED Lamp onto each Tail Light Mount using 1/4-20 X 1-1/2 Screws and Locknuts. See page 21C.
10. Secure both harnesses with tie straps, making sure to leave enough slack, where the drawbar
meets the frame, to allow the machine to raise and lower. Secure LED lamp harness molded
union to module bracket using Tie Straps. Bundle and secure any excess cord with tie straps.
See page 21C.
11. Raise, lower, fold and unfold machine to check for proper clearance, adjust accordingly.
Important: All wires must be firmly attached to machine frame members, or hydraulic lines, so they
don't sag or become torn loose by field debris. Use the cable and hose ties provided.
190rev0713
LED Lamp and Harness Installation
21D
9J698
Advertisement
Table of Contents
