Landoll Brillion XXL184 Operator's Manual page 36

Clevis Hitches:
Remove the Safety Chain and set aside.
Insert the Hitch Lock Up Channel into the Drawbar and line up bolt holes.
Insert 2-3/4" bolt into the righthand hole, thread Lock Nut on. Do Not fully tighten at this time.
Insert 4-1/2" bolt into the lefthand hole, slide four 1in Narrow Flat Washers over the bolt, then
Safety Chain, thread Lock Nut on. Do Not fully tighten at this time.
Position three 1-1/2 Flat Washers and two 1.56 x 3.5 x .75 Washers between the Hitch Lock Up Channel
and Hitch.
Position one 1-1/2 Flat Washer and one 1.56 x 3.5 x .75 Washer on top of the Hitch.
Insert Drilled Bolt up through the Hitch Lock Up Channel, Washers and Hitch.
Thread Slotted Nut onto Drilled Bolt,
Tighten all hardware.
To adjust angle of hitch, move washers from bottom to top or vice versa.
Bolt,1-8 x 2-3/4
Pin,Cotter
5/16 x 3-1/2
Lock Nut,1-8
Flat Washer,1-1/2
Hitch Lock Up
Channel
Drilled Bolt,
1-1/2 x 7
190rev501
Hitch Lock Kit - Optional
Do Not Remove Hitch to Install
tighten and
Bolt,1-8 x 4-1/2
Slotted Nut,1-1/2-6
1.56 x 3.5 x .75
Safety Chain
align drilled hole and nut, insert 5/16 x 3 Cotter Pin and spread fully.
Flat Washer,1-1/2
Washer,
Washer,1in Narrow
Lock Nut,1-8
Page 22B
Clevis Hitch
Set-Up
9J698