Dc Output - Ingeteam Ingecon mWind Interface Installation Manual

Installation manual Ingeteam Power Technology, S.A.
Check that the connector terminals have been correctly tightened. Re-insert the connector in the correct position.
Tighten the cable gland to ensure that the equipment is airtight.
The analog input cable diameter must not be greater than 9 mm.

5.3.6. DC output

The Ingecon μWind Interface and the Ingecon µWind power stages are connected through the DC voltage cable
® ®
supplied with the Ingecon µWind.
®
1. Connect the push-pull terminals of this cable to the inverter.
μWind TL
Ingecon
®
DC quick connectors
μWind with transformer
Ingecon
®
AAY2000IKI06 27