Removing The Engine From The Frame - APRILIA QUASAR 125 2003 Workshop Manual

QUASAR 125-180
3.1.2

REMOVING THE ENGINE FROM THE FRAME

Read carefully 1.3 (GENERAL SAFETY RULES).
Switch off the engine and wait for the engine and exhaust system to cool
down.
"
Remove both shields, see 6.1.5 (REMOVING THE FRONT SHIELD) and
see 6.1.6 (REMOVING THE REAR SHIELD).
"
Remove both footpegs, see
To clean the outer parts of the engine use a degreaser, brushes and
wipers.
Ensure that no rubber or plastic parts come in contact with detergents
and corrosive or penetrating solvents.
Should you need a steam cleaner, do not direct water, steam or high-
pressure air jets towards any of the following parts: wheel hubs,
handlebar controls, main warning lights, exhaust silencer, main switch.
"
Remove the exhaust system, see
PIPE).
"
Remove the airbox, see 2.10 (AIR CLEANER).
Mark cables, hoses and pipes to avoid confusing them when refitting.
"
Loosen and remove screw (1) and remove clip (2).
"
Disconnect the alternator connectors (3).
Release 00/2003 - 09
6.1.7 (REMOVING THE FOOTREST).
6.1.21 (REMOVING THE EXHAUST
ENGINE
1
2
3
3 - 5 -
00