Activate Marriage - Christie CP2210 Technical Bulletin

Remove and replace the ICP battery
1. Insert a flat screwdriver under the battery (A) and carefully lift it upward until it separates from
the retaining clip.
2. Remove the battery and set it aside.
Follow your local regulations for battery disposal.
3. Insert the new battery beneath the retaining clip.
Reinstall the ICP and reassemble the projector
1. Insert the ICP with even pressure into the card cage until it is firmly seated on the backplane.
2. Push the ejectors on the ICP faceplate inward to lock the ICP in position.
3. Replace the high security ring.
4. Replace the high security lid and lock it with the high security key.
5. Place the top lid on the projector and tighten the seven screws to secure it in position.
6. Reconnect the projector to AC power.
7. On the projector TPC, tap and hold the green power (

Activate marriage

You must complete marriage to display encrypted content and to comply with the Digital Cinema
Initiatives (DCI) specification.
1. Log on to the projector with marriage permissions.
2. Tap Menu > Service Setup > LD Marriage.
3. Complete the Marriage wizard.
4. Click Finish.
Replacing the ICP Battery Technical Bulletin
020-200313-01 Rev. 1 (02-2015)
) icon.
4