Backup Projector Settings And Information; Prepare The Projector For Service - Christie CP2210 Technical Bulletin

Replace the ICP battery
The ICP is installed in the card cage located on the operator (left) side of the projector facing the
lens. This procedure describes the replacement of an ICP battery in a Christie CP2215 projector. For
removal instructions that are specific to your projector model, see the projector Service Manual.
To prevent damage to the projector or personal injury, complete the procedures in the order they
are written.

Backup projector settings and information

This procedure is optional, but is recommended to make sure you can recover your data if an error
occurs.
1. Insert a USB flash drive into the USB port on the side of the projector touch panel controller
(TPC).
2. Log on to the projector with service permissions.
3. On the TPC, tap Menu > Service Setup > File Management.
4. Tap Backup.
5. When the backup is complete, remove the USB flash drive and store it in a secure location.

Prepare the projector for service

1. If the lamp is on, tap the lamp off (
2. Allow the lamp to cool for a minimum of 15 minutes.
3. Tap and hold the power off (
4. Disconnect the projector from AC power.
Remove the ICP
1. Loosen the seven screws that secure the top lid to the projector
2. Lift the lid up from the rear of the projector and set it aside.
Replacing the ICP Battery Technical Bulletin
020-200313-01 Rev. 1 (02-2015)
) icon on the projector TPC to turn it off.
) icon to turn the projector off.
.
2