Turning On The Projector; Projector Led Status Indicators - Christie Mirage 304K User Manual

Turning on the projector

When the projector AC power supply is plugged in, the power is on.
Warning! If not avoided, the following could result in death or serious injury.
• SHOCK HAZARD! Do not attempt operation if the AC supply is not within the specified voltage
and current, as specified on the license label.
1. Plug the projector in to AC power.
The projector automatically powers on to standby mode when plugged in. The display panel
functionality becomes available.
2. To turn the light source on using the projector keypad, press and hold the power
until you hear a beep.
To turn on the light source using the remote, press and hold the ON button until you hear a
beep.

Projector LED status indicators

Identify the LED state colors and meaning.
LED State
Blue Solid
Flashing
Green Solid
Flashing
Yellow Solid
Flashing yellow/green
Flashing
Flashing yellow/blue
Red Solid
Mirage 304K (Bm.1) User Guide
020-101778-12 Rev. 1 (04-2020)
Copyright © 2020 Christie Digital Systems USA, Inc. All rights reserved.
Description
Standby Light source is off. Video electronics are off.
Projector status is OK.
Cool down Projector is moving to one of the two standby
states:
• Light source is off and video electronics are
booting up.
• Light source is off. Video electronics and light
source is cooling down.
Light source on Light source is on. Projector status is OK.
Startup Projector is moving to light source on state. Light
source is warming up. Video electronics are
initializing.
Warning in Projector is in standby state. A problem exists with
standby the projector that does not prevent it from
operating.
Warning during Projector is in a startup state. A problem exists
startup with the projector that does not prevent it from
operating.
Warning with Light source is on. A problem exists with the
light source on projector that will not cause it to shut down.
Warning during Projector is in a cool down state. Light source is off.
cool down Video electronics and light source are cooling
down. A problem exists with the projector that
does not prevent it from operating.
Error in Projector is in standby. An error exists that
standby prevents the projector from starting up.
Introduction
button
20