Table of Contents
Advertisement
Page 24 · Robotics with the Boe-Bot
√
Begin by clicking the BS2 icon (the green diagonal chip) on the toolbar,
shown highlighted in Figure 1-35. If you hold your cursor over this button, its
flyover help description "Stamp Mode: BS2" will appear.
√
Next, click on the gear icon labeled "2.5" shown highlighted in Figure 1-36.
Its flyover help description is "PBASIC Language: 2.5".
Figure 1-35
BS2 Icon
Clicking on this button will
automatically place '{$STAMP BS2}
at the beginning of your program.
ALWAYS use these toolbar buttons to add these two lines as the beginning of every
program! Compiler directives use braces
program, you may accidentally use parentheses
this, your program will not work.
√
Type the rest of the program into the BASIC Stamp Editor exactly as shown in
Figure 1-37. Notice that the first two lines are above the compiler directives, and
the rest of the program is below the compiler directives.
Figure 1-36
PBASIC 2.5 Icon
Clicking on this button will automatically
place '{$PBASIC 2.5} at the beginning
of your program.
{ }
.
If you try to type in these parts of your
( )
or square brackets
[ ]
.
If you do
Advertisement
Table of Contents
