Table of Contents
Advertisement
(1) BASIC Stamp HomeWork Board
√
Remove each rubber foot from its adhesive strip and affix it to the underside of
the HomeWork Board next to each plated hole at each corner of the board as
shown in Figure 1-28, making sure not to cover up the holes.
√
Connect the serial cable and battery to the HomeWork Board (Figure 1-29, steps
1 and 2).
Chapter 1: Your Boe-Bot's Brain · Page 19
Figure 1-27
Getting Started Hardware
for the BASIC Stamp
HomeWork Board
Figure 1-28
Rubber Feet
Advertisement
Table of Contents
