Table of Contents
Advertisement
√
Remember to disconnect power from your system (board and servos) when you
are done. That means setting the 3-posisiton switch to position-0 if you have a
Board of Education Rev C. If you have a HomeWork Board, disconnect the 9 V
battery from the battery clip and remove one battery from the battery pack.
TIP – To measure the run time, press and hold the Reset button on your Board of Education
(or BASIC Stamp HomeWork Board). When you are ready to start timing, let go of the
Reset button.
Chapter 2: Your Boe-Bot's Servo Motors · Page 85
Advertisement
Table of Contents
