Table of Contents
Advertisement
Mandatory action
Disconnect all power sources before performing
maintenance or service procedures.
Consult the service manual.
Disconnect all power sources before performing
maintenance or service procedures.
Electrical labels
Indicates the presence of an earth ground.
Additional hazard labels
Learn about additional labels that appear on the product.
Indicates thermal radiation emitted from the product may
cause burns.
Indicates possible optical radiation emitted from the product.
Important safeguards
To prevent personal injury and to protect the device from
damage, read and follow these safety precautions.
General safety precautions
Read all safety and warning guidelines before installing or
operating the projector.
Warning! Failure to comply with the following could
result in death or serious injury.
CP2308-C Product Safety Guide
020-102493-01 Rev. 1 (12-2016)
Copyright
2016 Christie Digital Systems USA Inc. All rights reserved.
©
•
TRIP OR FIRE HAZARD! Position all cables where
they cannot contact hot surfaces, be pulled, be
tripped over, or damaged by persons walking on
or objects rolling over the cables.
•
For protection from ultraviolet radiation, keep all
product housings intact during operation.
•
UV EXPOSURE! Protective UV safety glasses with
side shields and Christie approved protective
safety clothing must be worn when performing
optical adjustments or servicing the product.
•
FIRE AND SHOCK HAZARD! Use only the
attachments, accessories, tools, and
replacement parts specified by Christie.
•
FIRE HAZARD! Do not use a power cord,
harness, or cable that appears damaged.
•
A minimum of four people or appropriately rated
lift equipment is required to safely lift, install, or
move the product.
Caution! Failure to comply with the following could
result in minor or moderate injury.
•
Only Christie qualified technicians are permitted
to open product enclosures.
Lamp safety precautions
Read all safety and warning guidelines before installing the
projector lamp.
Warning! Failure to comply with the following could
result in death or serious injury.
•
This procedure must be performed by Christie
qualified technicians.
•
EXPLOSION HAZARD! Always wear
manufacturer approved protective safety
clothing (gloves, jacket, face shield) whenever
the lamp door is open or when handling the
lamp. Any local or federal specifications take
precedence over Christie's protective clothing
recommendations.
•
Do not open the lamp door while the lamp is on.
•
EXPLOSION HAZARD! Allow sufficient time for
the lamp to cool down before powering down
the product, disconnecting it from AC, and
opening the lamp door.
•
EXPLOSION HAZARD! Do not stress the glass of
a lamp or bare bulb in any way.
•
EXPLOSION HAZARD! Lamps and bare bulbs,
even when packaged, may explode if dropped or
mishandled.
•
EXPLOSION HAZARD! Handle a lamp by the
cathode and anode end shafts only. Do not
handle the lamp by the glass.
•
EXPLOSION HAZARD! Do not over-tighten the
lamp.
•
Do not look directly into the lens or at the lamp.
The extremely high brightness can cause
permanent eye damage.
Important Safety Information
3
Advertisement
Table of Contents
