Behaviour In Response To Original Module Errors - Festo CPX Series Description

5. Diagnostics and error handling

5.3.1 Behaviour in response to original module errors

Channe FP LED
l error
LED
Tab. 5/7: Behaviour in response to module errors
5-10
Module Error Error description
error no.
LED
5 Undervoltage in supply
voltage
61 Overvoltage in supply
voltage
65 Set PROFIsafe address
does not correlate with
safety parameterisation
(F_Dest_Add)
66 Error in safe
communication
67 The chronological
sequence for PROFIsafe
communication is
impaired
69 Error in safe
parameterisation (safety
parameterisation
invalid)
75 Overtemperature of
the input module
Short circuit/overload
in a clock output
145 Input module has
detected an error
during the self-test
All input channels on the input module are passivated in
response to module errors.
After remedial action: reintegrate the input module.
•
Remedy
Correct supply voltage or
•
remedy the short circuit
Correct supply voltage
•
Check and correct set
•
address/parameter
è Chapter 2.4 and 3.8
Transmit new parameters
•
Rectify source of error
•
Check the communication
•
paths
Check timeout time
•
è Chapter 3.8
Check parameters in the
•
PROFIsafe protocol
Transmit new parameters
•
Remedy overtemperature
•
Remedy short circuit/
•
overload on T0, T2, T4, T6
Switch CPX terminal on
•
again
Replace input module
•
Festo CPX-F8DE-P-EN en 2005b English