Configuration With Siemens Step 7 (Example) - Festo CPX Series Description

3. Commissioning
3.8

Configuration with Siemens STEP 7 (example).

"Addresses"
tab
"Parameters"
tab
Festo CPX-F8DE-P-EN en 2005b English
The configuration examples shown in this chapter are based
on the use of a Siemens PLC and the Siemens STEP 7 version
5.4 configuration and programming software with Distributed
Safety version 5.4. PROFIBUS or PROFINET IO is used as the
bus system.
The following section requires familiarity with the operation of
the STEP 7 software.
Information on the configuration and commissioning of the
CPX terminal can be found in the description of the bus node.
1. Integrate the GSDML/GSD file in the configuration
software of the F-Host è Description of the bus node.
2. Configure the CPX terminal including the input module
with the configuration software of the F-Host:
Import CPX terminal into the configuration è Description
of the bus node.
3. In the configuration table double-click the row of the input
module CPX-F8DE-P.
The "Properties – F8DE-P" dialogue box is displayed.
4. Set the required starting addresses for inputs and
outputsè Fig. 3/3.
5. Set default parameters on the input module.
In online mode the PROFIsafe addresses of the DIL
switch settings are displayed here.
3-13