BONFIGLIOLI Vectron ACTIVE CUBE Series Applications Manual page 54

Positioning mode "Gearing, direct synchronisation"
Activation of motion mode "Gearing, direct synchronisation"
− Parameter
− Parameter
− Parameter
With Touch-Probe signal:
− Parameter
− Parameter
Gearing, direct synchronisation
52
52
Motion Mode
Motion Mode
Motion Mode
Motion Mode
Edge" or
Motion Mode
edge"
1. Synchronisation of slave position and position of master drive
2. Acceleration with ramps from the motion block
3. Synchronisation message via logic signal "In Gear"
Start Positioning
In Gear
Speed
Master speed
Position
Application manual Positioning
Application manual Positioning
1208 = "20 - Gearing, direct sync., absolute" or
1208 = "21 - Gearing, direct sync., relative" or
1208 = "24 - Gearing direct synchronisation"
1208 = "22 - Gearing, direct sync., Touch-Probe, pos.
1208 = "23 - Gearing, direct sync., Touch-Probe, neg.
3.
V
2.
Position Controller
1.
V
Soll
S
Master
∆s,
Start
Acceleration
( 1204 )
+ V
Ref Position Controller
Limitation
1118
t
∆s,
Start
S
Slvave
t
04/08
04/08