Digital Positioning Output Signals - BONFIGLIOLI Vectron ACTIVE CUBE Series Applications Manual

6.4
Parameters
Mode Digital Output 3
functions.
The use of the multifunctional output MFO1 as a digital output requires parameter-
setting
tion MFO1
The following output signals of the positioning function can be assigned to the digital
outputs. For information on other operation modes, refer to the operating instruc-
tions of the frequency inverter.
04/08 04/08

Digital Positioning Output Signals

OP. Mode Digital Output 1
532 of f the relay output link the digital outputs to various
Operation mode
550 = "1 - Digital" and linking via parameter
554.
Digital signals
Warning messages of error/warning behavior function (HW
limit switches, SW limit switches and contouring error moni-
Warning,
26 -
Application toring of positioning function). The warnings are displayed as
actual values via parameter
Warning
Message of the configurable parameter
27 - Mask, Applica-
Application
tion
Master position evaluated by slave was offset by value of pa-
56 - Phasing Done
rameter
In
10 to 14), synchronous operation of electronic gear was
57 - In Gear
reached. Slave drive is engaged at current position and oper-
ates at a synchronous angle with master. Slave drive is syn-
chronized with master frequency.
Current position value is in the range between
Position Com-
58 - 1243 and
parator
ter
Message is triggered by homing operation or in
59 - Homing Done
1208 with touch probe by taking over current position as
reference position.
Target Position / Distance
was reached, and current act. position is within the range set
Target Posi-
60 -
tion Reached in parameter
Target window time
Warning De-
The contouring error monitoring
61 - viation of
was exceeded.
Position
Motion-Block Message on status of a travel order during a positioning op-
eration. The conditions set for parameter
62 - Digital Signal
1
1218 were fulfilled.
Motion-Block Message on status of a travel order during a positioning op-
63 - Digital Signal eration. The conditions set for parameter
2
1219 were fulfilled.
Message on status of a travel order during a positioning op-
Motion-Block
64 - Digital Signal eration. The conditions set for parameter
3 1247 were fulfilled.
Motion-Block Message on status of a travel order during a positioning op-
Digital Signal eration. The conditions set for parameter
65 -
4
1248 were fulfilled.
126-165 Operation modes 26 to 65, inverted.
Application manual Positioning Application manual Positioning
530 of digital output S1OUTD and
Function
626.
Phasing: Offset
1125.
Motion Mode
1208 with electronic gear (operation modes
Off-Position
1244. The value selected in parame-
Hysteresis
1245 is considered.
Target window
1166.
Digital opera-
Application Warnings
273.
Create Warning Mask
On-Position
Motion Mode
1202 of a positioning operation
1165 for a minimum period of
Warning Threshold
Digital Signal 1
Digital Signal 2
Digital Signal 3
Digital Signal 4
Op.
1105
155 155