Access Control List Configuration - Planet IGS-5225 Series User Manual

• Action
• Rate Limiter
• CPU
• Counter
• Conflict
Buttons
Auto-refresh : Check this box to refresh the page automatically. Automatic refresh occurs every 3 seconds.
: Click to refresh the page.

4.5.5.2 Access Control List Configuration

This page shows the Access Control List (ACL), which is made up of the ACEs defined on this switch. Each row describes the
ACE that is defined. The maximum number of ACEs is 512 on each switch.
Click on the lowest plus sign to add a new ACE to the list. The reserved ACEs used for internal protocol, cannot be edited or
deleted, the order sequence cannot be changed and the priority is highest. The Access Control List Configuration screen in
Figure 4-5-5-2 appears.
IPv4: The ACE will match all IPv4 frames.
■
IPv4/ICMP: The ACE will match IPv4 frames with ICMP protocol.
■
IPv4/UDP: The ACE will match IPv4 frames with UDP protocol.
■
IPv4/TCP: The ACE will match IPv4 frames with TCP protocol.
■
IPv4/Other: The ACE will match IPv4 frames, which are not
■
ICMP/UDP/TCP.
IPv6: The ACE will match all IPv6 standard frames.
■
Indicates the forwarding action of the ACE.
Permit: Frames matching the ACE may be forwarded and learned.
■
Deny: Frames matching the ACE are dropped.
■
Indicates the rate limiter number of the ACE. The allowed range is 1 to 16. When
Disabled is displayed, the rate limiter operation is disabled.
Forward packet that matched the specific ACE to CPU
The counter indicates the number of times the ACE was hit by a frame.
Indicates the hardware status of the specific ACE. The specific ACE is not
applied to the hardware due to hardware limitations.
Figure 4-5-5-2: Access Control List Configuration Page Screenshot
User's Manual of IGS-5225 series
359