Planet IGS-5225 Series User Manual page 339

• Other Info
Tx Timeouts
This section contains information about the state of the server and the latest round-trip
time.
Name RFC4670 Name
IP Address -
State -
Round-Trip
radiusAccClientExtRo
Time
undTripTime
339
User's Manual of IGS-5225 series
radiusAccClientExt The number of accounting
Timeouts timeouts to the server. After a
timeout, the client may retry to
the same server, send to a
different server, or give up. A
retry to the same server is
counted as a retransmit as
well as a timeout. A send to a
different server is counted as a
Request as well as a timeout.
Description
IP address and UDP port for the accounting
server in question.
Shows the state of the server. It takes one of
the following values:
Disabled: The selected server is disabled.

Not Ready: The server is enabled, but IP

communication is not yet up and running.
Ready: The server is enabled, IP

communication is up and running, and the
RADIUS module is ready to accept
accounting attempts.
 Dead (X seconds left): Accounting
attempts were made to this server, but it
did not reply within the configured timeout.
The server has temporarily been disabled,
but will get re-enabled when the dead-time
expires. The number of seconds left
before this occurs is displayed in
parentheses. This state is only reachable
when more than one server is enabled.
The time interval (measured in

milliseconds) between the most recent
Response and the Request that matched
it from the RADIUS accounting server.
The granularity of this measurement is