Work Lights; Flashing Light; Rcd/Elcb Ac Outlet; Sandblast Protection Kit - Snorkel MHP1335 Operation Manual

Work Lights

Rub ber en cased work lights can be fit ted to the
plat form guard rails. The lights are swivel mounted
and each has its own switch.

Flashing Light

For this option see Chapter 2 page 3

RCD/ELCB AC Outlet

A 3 core wire rated at 600 volts AC 15 amps is run
up the booms as stan dard.
For this option see Chapter 2 Page 3.

Sandblast Protection Kit

This op tion con sists of a bel lows type cover fit ted to
each boom cyl in der shaft.
The bel lows pre vent sand and paint from dam ag ing
the cyl in der rods and seals, and thus pre vent hy -
drau lic oil leaks.
CAUTION
DO NOT paint or sandblast from an
MHP13/35 / MHP15/44 V3 unless the cylinder
rods are protected by bellows.

Platform Rotator

This op tion al lows the op er a tor to move the plat -
form around the boom, 45
gain better ac cess to work sites.

Lifting Lugs / Hoisting

This op tion con sists of a mod i fi ca tion of the sta bi -
liser foot plates to al low for ma chine lift ing/hoist ing.

Spare Wheel

Mounted on the drawbar this is an ideal op tion, es -
pe cially so for ma chines that reg u larly travel in iso -
lated coun try ar eas.
MHP13/35 & MHP15/44 V3 – 13619-1
o
each side of cen ter, to
Rev C
Fig ure 11.6 - Spare Wheel

10.9 Metre Height Restriction Kit

This kit may be fit ted to MHP15/44 Mark II ma -
chines man u fac tured for the Aus tra lian mar ket to
com ply with Aus tra lian leg is la tion.
For ma chines fit ted with this kit a key switch is pro -
vided on the lower con trol box .
This switch al lows the ma chine to op er ate to its full
boom height of 13.4m when the switch is in the
DISABLED po si tion or to the re stricted height of
10.9m when the switch is in the ENABLED po si tion
see fig ure be low.
This key switch is fit ted in the lower left hand cor ner
of the lower con trol box.
ENABLED ENABLED DISABLED DISABLED
HEIGHT HEIGHT
LOCKOUT LOCKOUT
Figure 11.7 - Height Lockout Switch
WARNING
The use of this machine in the unrestricted
mode (over 10.9m) by an uncertified
operator is a breach of Australian law.
In order to operate this machine in the
unrestricted mode the operator is required
to hold a WP Certificate of
IMPORTANT
The key MUST NOT be left in the machine by
a qualified operator when the machine is
unattended.
11. Options
13573-
Competency.
page 11 - 3