Related Manuals for Snorkel M1230E
Summary of Contents for Snorkel M1230E
- Page 1 OPERATORS MANUAL Part Number 512437-000-EN January 2013 Serial Number 000001 and after...
- Page 3 M1230E ENGLISH When contacting SNORKEL for service or parts information, be sure to include the MODEL and SERIAL NUMBERS from the equipment nameplate. Should the nameplate be missing, the SERIAL NUMBER is also stamped on top of the chassis above the front axle pivot.
- Page 4 NEVER charge batteries near sparks or open flame. Charging batteries emit explosive hydrogen gas. Modifications to the aerial work platform are prohibited or permissible only at the approval by Snorkel. AFTER USE, secure the work platform from unauthorized use by turning the keyswitch off and removing key.
- Page 5 Harness attachment points are provided in the platform and the manufacturer recommends the usage of a fall restraint harness, especially where required by national safety regulations. All harness attachment points on SNORKEL vehicles have been tested with a force of 3,650 lbs (16.3 KN) per person.
-
Page 6: Table Of Contents
CONTENTS Introduction ..............................3 General ................................3 Special Limitations ............................. 4 Platform Capacity ............................4 Manual Force ............................4 Beaufort Scale ............................4 Controls and Indicators ..........................5 Pre-Operation Safety Inspection ........................ 5 System Function Inspection ........................6 Operation ..............................7 Travel With Platform Lowered ........................7 Steering .............................. -
Page 7: Introduction
Introduction INTRODUCTION This manual covers all models of the M1230E Aerial Work Platform. This manual must be stored on the machine at all times. Read, understand and follow all safety rules and operating instructions before attempting to operate the machine. -
Page 8: Special Limitations
The work platform is NOT intended to be driven over uneven, rough, or soft terrain. PLATFORM CAPACITY The maximum platform capacity for the M1230E is 227 kg (500 lbs). Two people may occupy the platform indoors, while only one may occupy the platform outdoors. -
Page 9: Controls And Indicators
Controls and Indicators CONTROLS AND INDICATORS The operator shall know the location of each control and indicator and have a thorough knowledge of the function and operation of each before attempting to operate the unit. Figure 2: Controls and Indicators Platform Controller 510428-001... -
Page 10: System Function Inspection
System Function Inspection SYSTEM FUNCTION INSPECTION Refer to Figure 1 and Figure 2 for the locations of various controls and indicators. W A R N I N G STAND CLEAR of the work platform while performing the following checks. Before operating the machine, survey the work area for surface hazards such as holes, drop-offs, bumps and debris. -
Page 11: Operation
Operation OPERATION Before operating the machine, ensure that the Pre-Operation Safety Inspection has been completed and that any deficiencies have been corrected. Never operate a damaged or malfunctioning machine. The operator must be thoroughly trained on this machine. TRAVEL WITH PLATFORM LOWERED 1. -
Page 12: Emergency Lowering
Operation EMERGENCY LOWERING W A R N I N G If the platform should fail to lower, NEVER climb down the elevating assembly. Stand clear of the elevating assembly while operating the Emergency Lowering Valve Knob. Figure 4: Emergency Lowering Valve Ask a person on the ground to open the Emergency Lowering Valve to lower the platform. -
Page 13: Transporting The Machine
Transporting the Machine TRANSPORTING THE MACHINE BY CRANE Secure the straps to chassis lifting/tie down points only. BY FORKLIFT D A N G E R Forklifting is for transport only. See specifications for weight of machine and be certain that forklift is of adequate capacity to lift the machine. -
Page 14: Maintenance
Maintenance MAINTENANCE W A R N I N G Never perform service while the platform is elevated without first blocking the elevating assembly. DO NOT stand in the elevating assembly area while deploying or storing the brace. Figure 7: Supporting the Elevating Assembly BLOCKING THE ELEVATING ASSEMBLY INSTALLATION 1. -
Page 15: Battery Maintenance
Always wear safety glasses when working near batteries. Battery fluid is highly corrosive. Thoroughly rinse away any spilled fluid with clean water. Always replace batteries with SNORKEL batteries or manufacturer approved replacements weighing 26,3 kg (58 lbs.) each. • Check the battery fluid level daily, especially if the machine is being used in a warm, dry climate. -
Page 16: Inspection And Maintenance Schedule
Inspection and Maintenance Schedule INSPECTION AND MAINTENANCE SCHEDULE The Complete Inspection consists of periodic visual and operational checks, along with periodic minor adjustments that assure proper performance. Daily inspection will prevent abnormal wear and prolong the life of all systems. The inspection and maintenance schedule should be performed at the specified intervals or at intervals to suit the relevant national body whichever is the lesser. -
Page 17: Daily Preventative Maintenance Checklist
Daily Preventative Maintenance Checklist DAILY PREVENTATIVE MAINTENANCE CHECKLIST MAINTENANCE TABLE KEY PREVENTATIVE MAINTENANCE REPORT Y = Yes/Acceptable Date: ________________________________________ N = No/Not Acceptable Owner: ______________________________________ R = Repaired/Acceptable Model No: ____________________________________ Serial No: _____________________________________ Serviced By: __________________________________ COMPONENT INSPECTION OR SERVICES COMPONENT INSPECTION OR SERVICES Check electrolyte level. -
Page 18: Specifications
Specifications SPECIFICATIONS ITEM M1230E Platform Size 74cm x 96cm (29 in. x 38 in.) Maximum Platform Capacity 227 kg (500 lbs.) Maximum Number of Occupants 2 People indoors/1 person outdoors Height 5,6 m (18 ft.) Working Height 3,63 m (11 ft. 11 in.) Maximum Platform Height 48,3 cm (19 in.) - Page 20 Local Distributor / Lokaler Vertiebshändler / Distributeur local El Distribuidor local / ll Distributore locale EUROPE, MIDDLE EAST AFRICA & ASIA PHONE: +44 (0) 845 1550 057 FAX: +44 (0) 845 1557 756 NORTH & SOUTH AMERICA PHONE: +1 785 989 3000 TOLL FREE: +1 800 225 0317 FAX: +1 785 989 3070 AUSTRALIA...