Snorkel MHP1335 Operation Manual page 15

DANGER
BEWARE OF ELECTRICAL HAZARDS
REGULATION 133A OF THE
CONSTRUCTION SAFETY ACT 1912 REQUIRES
(a) Minimum approach of an appliance
to live electrical apparatus.
(b) Inspection of the work site for
electrical hazards before
commencing to use the appliance.
(c) Constant vigilance and an observer required
whilst working or travelling the appliance
in the vicinity of live electrical apparatus.
(Australia Only)
WARNING
KEEP CLEAR OF POWER
Unless the Electrical Supply Authority has advised
in writing otherwise;
the clearance between any live overhead
power line and any part of this machine or
load carried is required by law to be
AT LEAST 4 METRES
This is a requirement of regulation 93 of the
Electrical Supply Regulations 1984
in the interests of safe working.
(New Zealand Only)
CAUTION
EACH PERSON ON THE PLATFORM
MUST WEAR A FULL SAFETY HARNESS
WITH LEG STRAPS
AND ENERGY ABSORBING LANYARD
ATTACHED TO AN APPROVED ANCHOR
POINT IN THE PLATFORM
NOTE:
Refer to Placards and Decals Inspection Chart and Drawing in the "Daily Inspection and
Maintenance" chapter 7, for part numbers, location, and required quantities of all placards and
decals.
MHP13/35 & MHP15/44 V3 – 13619-1
3m. for voltages up to 132,000
6m. for voltages above 132,000
and up to 330,000
8m. for voltages above 330,000
9428
9428
LINES
1843
1843
99228-1
99228-1
AFTER SERIAL NUMBER NZ070801
DANGER
ELECTROCUTION
HAZARD
THIS MACHINE IS NOT
ELECTRICALLY INSULATED
BEFORE SERIAL NUMBER NZ070801
DANGER
MAXIMUM ALLOWABLE
WIND SPEED 12.5m/sec
RATED LOAD
440
RATED LOAD
500
Note: Rated capacity depends on
the configuration of the machine
see Chapter 3 - Specifications
Rev C
1. Safety
13030
13030
ELECTROCUTION HAZARD
This machine is not electrically insulated.
45198-7
0072531
0150448
0150448
200 KG
LB
12423-200
12423-200
LB 227 KG
12423-227
12423-227
page 1 - 7
0072531
0072531