Restoring Factory Defaults (Specific Models)
DeviceMaster MOD | UP Hardware Installation and Configuration Guide: 2000630 Rev. B
5. Click Ok to the second
Upload Firmware message.
6. Right-click the DeviceMaster
and click Refresh until the
Bootloader version displays
in the Device List pane and
verify that the new version
loaded.
Use the following procedures to restore the DeviceMaster DIN rail models to the
factory defaults.
If Technical Support advises you to restore the DeviceMaster factory defaults,
depress the Reset/Restore switch for greater than 5 seconds.
Restoring the DeviceMaster DIN rail models resets the following to their factory
defaults:
•
Port settings
•
Network settings
•
Password
•
Telnet enable
•
Start up time-out
•
SSL enable
•
Telnet time-out
Managing the DeviceMaster
Managing the DeviceMaster - 67