Comtrol DeviceMaster MOD Series Hardware Installation And Configuration Manual page 40

Preparing the DeviceMaster for Configuration
40 - Preparing the DeviceMaster for Configuration
5. Click Yes to upload the firmware.
6. Click OK to the advisory message about waiting until the DeviceMaster is on-
line and in the next minute the DeviceMaster unit or units should display ON-
LINE in the Status field.
7. Go to the appropriate Quick Start or User Guide for your protocol for
information about configuring the serial port or ports using the web page and
programming your PLCs. See
12 to locate the document for your protocol.
If you are planning on installing multiple DeviceMasters, you may want to use
the Save/Load Configuration File feature in PortVision DX.
A configuration file can contain network settings and protocol settings. Refer
to the PortVision DX help system for information about saving and loading
configuration files.
8. After configuring the serial port characteristics and preparing your PLC
programs, you can use the next section in this guide, to attach the serial device
or devices.
DeviceMaster MOD | UP Hardware Installation and Configuration Guide: 2000630 Rev. B
Locating Software and Documentation on Page