Comtrol DeviceMaster MOD Series Hardware Installation And Configuration Manual page 78

RedBoot Procedures
mcmp -s <location>
-s <location>
-d <location> -l <length>
[-1|-2|-4]
mcopy -s <location>
-d <location> -l <length>
[-1|-2|-4]
mfill -b <location> -l <length>
-p <pattern> [-1|-2|-4]
model†
numether [num]†
numserial [num]†
oemid [id]†
password {password}
ping [-v] [-n <count>]
[-l <length>] [-t <timeout>]
[-r <rate>]
[-i <IP_addr>] -h <IP_addr>
ramtest <passes>
ramtime [reg [<value>]]
reset
secureconf [disable|enable]
securedata [disable|enable]
sernum [prefix] [serial_number]
sernum [serial_number]†
?
snmp [disable|enable]
summary
telnet [disable | enable}
teltimeout [seconds]
terse
t485 port #1 port #2
timeout {seconds}
version
x -b <location> [-l <length>] [-s] [-
1|2|4]
kszdump
kszrd <r1> [r2]
kszrestart
kszwr <r1> <val>
† Read-only items that you cannot change in Redboot.
78 - RedBoot Procedures
RedBoot Commands (Continued)
Compares two blocks of memory.
Copies memory from one address to another.
Fills a block of memory with a pattern.
Shows model number.
Shows number of Ethernet ports.
Shows number of serial ports.
Shows OEM id.
Sets or deletes the password.
Network connectivity test.
Test the RAM.
Shows RAM timing register values.
Resets the DeviceMaster.
Sets or displays secure config enable.
Sets or displays secure data enable.
Displays device serial number (if available).
Displays short help.
Sets or displays SNMP enable.
Displays a summary that includes the bootloader version, network
address information, MAC address, and security settings.
Sets or displays telnet server enable. Disables telnet.
Shows or sets telnet time-out.
Terse command response mode.
Runs port-to-port RS-485 test. This is not available on the
DeviceMaster Serial Hub. Port numbering is Port 0 through 15 and you
must connect a straight-through cable such as Ethernet patch cord.
Displays or sets Bootloader time-out value.
Displays RedBoot version information.
Displays (hex dump) a range of memory.
Dumps a pre-determined set of KSZ8863 registers
Reads specified KSZ8863 registers.
Restarts KSZ8863.
Reads specified KSZ8863 registers.
DeviceMaster MOD | UP Hardware Installation and Configuration Guide: 2000630 Rev. B