Turning On The Projector With Low Voltage; Implementing Stealth Mode - Christie 4K40-RGB User Manual

The display changes to the appropriate color.
e) Record the luminance value from the spectroradiometer.
f) Click on the Blue luminance setting.
The display changes to the appropriate color.
g) Record the luminance value from the spectroradiometer.
h) For the remaining three points, repeat steps a to g.
15. Select MENU > Configuration > Horizontal 1D Color Uniformity > Color Uniformity
Mode.
16. To enable color uniformity, select Horizontal 1D Color Uniformity.
17. Select Enter.
18. To verify 1D color uniformity is working, enable a flat white test pattern.
Related information
Selecting an engine test pattern (on page 57)

Turning on the projector with low voltage

Enable the projector to turn on even if the AC mains voltage is below specification.
1. From the display panel, select MENU > Admin > Service.
2. Enter the service password.
The password is only required for the display panel and not the web user interface.
3. Select Ignore Low AC Input Voltage Error.
4. To ignore the Low AC Input Voltage error when turning on the projector, select Enter.

Implementing Stealth mode

When Stealth mode is enabled, the status and shutter LEDs are turned off and the heartbeat feature
on the display panel Enter key is disabled.
1. Select MENU > System Settings > Power Settings > Stealth Mode.
2. To disable the LEDs and heartbeat feature, select Enter.
3. To enable the LEDs and heartbeat feature, select Stealth Mode again.
4K40-RGB User Guide–D4K40-RGB, Roadie 4K40-RGB
020-102958-05 Rev. 1 (04-2020)
Copyright © 2020 Christie Digital Systems USA, Inc. All rights reserved.
Configuring system settings
41