Identifying where alarm and trap messages are
sent
Configure the email address and SNMP trap destination where alarms are recorded.
Creating a distribution mailing list for SNMP alerts means that changes to the people receiving the
emails does not require a change to the MIB browser configuration.
Setting the SNMP read community string
The SNMP read community string is similar to a userid or password that allows access to the device.
1. Select MENU > Communications > SNMP > SNMP Read Community.
2. Use the up and down arrows to enter the read community string.
3. To confirm your selection, select Enter.
Configuring traps
A trap is a condition that SNMP monitors on 4K40-RGB.
1. Select MENU > Communications > SNMP > Trap Configuration.
2. Select the trap you want to enable and select Enter.
The available traps are:
•
Fan Stall
•
Thermal Sensors
•
Power
•
Video Signal
3. To enable additional traps, repeat step 2.
Defining a trap IP address
When a trap condition is met, a notification is sent using an SNMP notification to one or more specified
IP addresses.
1. Select MENU > Communications > SNMP.
2. Select Address 1.
3. Use the up and down arrows to enter an IP address.
4. To confirm the address, select Enter.
5. To add a second and third IP address, repeat steps 2 to 4 for Address 2 and Address 3.
Restoring factory default settings
Restoring factory settings removes all custom device settings.
Only Christie qualified technicians can reset factory defaults.
1. From the display panel, select MENU > Admin > Service.
4K40-RGB User Guide–D4K40-RGB, Roadie 4K40-RGB
020-102958-05 Rev. 1 (04-2020)
Copyright
©
2020 Christie Digital Systems USA, Inc. All rights reserved.
Diagnostic tools
58