Christie 4K40-RGB User Manual page 40

3. Power on the projector.
4. Allow the light source to stabilize.
5. Select MENU > Configuration > Horizontal 1D Color Uniformity > Color Uniformity
Mode.
6. To disable color uniformity, select Color Uniformity Off.
7. Select Enter.
8. Select MENU > Image Settings > Color & Gamma > Color Correction Mode.
9. Select Max Drives and to confirm your selection, select Enter.
10. Select Show Color Pattern > Auto and to confirm your selection, select Enter.
11. From the side panel home page, use the arrows to select Test Pattern.
12. Select the 17 Point test pattern and to confirm your selection, select Enter.
13. Record the x, y, and RGB luminance values for the center point.
a) Point the spectroradiometer at point 5 (middle square).
b) Click the X value.
c) Record the x value from the spectroradiometer.
d) Click the Y value.
e) Record the y value from the spectroradiometer.
f) Click on the Red luminance setting.
The display changes to the appropriate color.
g) Record the luminance value from the spectroradiometer.
h) Click on the Green luminance setting.
The display changes to the appropriate color.
i) Record the luminance value from the spectroradiometer.
j) Click on the Blue luminance setting.
The display changes to the appropriate color.
k) Record the luminance value from the spectroradiometer.
14. Record the luminance values for the remaining four points (2—inside left, middle square; 15—
far left, middle square; 8—inside right, middle square; and 16—far right, middle square)
a) Point the spectroradiometer at a point.
b) Click on the Red luminance setting.
The display changes to the appropriate color.
c) Record the luminance value from the spectroradiometer.
d) Click on the Green luminance setting.
4K40-RGB User Guide–D4K40-RGB, Roadie 4K40-RGB
020-102958-05 Rev. 1 (04-2020)
Copyright © 2020 Christie Digital Systems USA, Inc. All rights reserved.
Configuring system settings
40