Table of Contents
Advertisement
SC800 T3 Operation
SC800 T3 Maintenance Screen
At the SC800 T3 Main Menu, press 4 and then press Enter to access the Maintenance screen,
shown below.
the Firmware Download submenu.
Table 3-9
Maintenance Selections
Selection
[1] What Are You
[2] Soft Reset
[3] Set to Factory Defaults
[4] Reset Statistics
[5] Firmware Download
[0] Return to Main Menu
Note
!IMPORTANT! Commanding the DSU to either [2] Soft Reset or [3] Set to Factory Defaults will disrupt
communications.
3-18
Table 3-9
describes the maintenance commands on this screen.
Read-only display of the serial number, firmware revision, boot code
revision, and the type of shelf the DSU is installed in.
Causes the DSU to perform a reset and resume operation using its
current configuration. Type [Y]es at the Confirmation prompt to
proceed.
Causes all options in the DSU to return to their factory default settings.
Type [Y]es at the Confirmation prompt to proceed.
Advances to the Reset Statistics Selections screen, described below.
Advances to the Firmware Download screen, described below.
Exits the Maintenance menu and returns to the Main Menu.
SpectraComm 800 T3 Data Service Unit
Installation and Operation Manual
SC800 T3 Maintenance Screen
Table 3-10
Description
076R160-000
Issue 4
describes
Advertisement
Table of Contents
