General DataComm SpectraComm 800 T3 Installation & Operation Manual page 5

Scope of this Manual
This manual describes installation and operation of the SpectraComm 800 T3 (SC800 T3). This
document is intended for network operators and installers and assumes a working knowledge of
data communication equipment.
The information in this manual has been carefully checked and is believed to be entirely reliable.
However, as General DataComm improves the reliability, function and design of its products, it is
possible that information herein may not be current. Check the General DataComm website at
http://www.gdc.com for updated manuals and product information, or contact your General
DataComm field representative.
General DataComm, Inc.
6 Rubber Avenue
Naugatuck, Connecticut, USA 06770
Tel: 1 203 729-0271
Safety Information
This manual should be read in its entirety and all procedures completely understood before
installing or operating the unit. The notes that appear throughout this manual must be read prior to
any installation or operating procedure. Examples of notes used in this manual are shown below.
Note A note provides essential operating information not readily apparent which you should be
particularly aware of. A note is typically used as a suggestion.
Important Indicates an emphasized note. It is something you should be particularly aware of; something
not readily apparent. Important is typically used to prevent equipment damage.
076R160-000
Issue 4
SpectraComm 800 T3 Data Service Unit
Installation and Operation Manual
Preface
iii