Diagnostics
End-to-End Self Test
T3 End to End Self Test turns on the T3-level test pattern generator and checker in the DSU. Use
of this test requires coordination with the remote site, either to establish a loopback or to activate a
test pattern generator and checker (using the same pattern) for an end-to-end test.
In this test, the following conditions occur:
•
Errors inserted are sent to the remote unit.
•
Errors counted have been sent by the remote unit.
Note
A remote telnet can not be used to set a loopback at the remote.
MASTER SC800 T3 DSU
TEST
PATTERN
GENERATOR
DTE
INTERFACE
TEST
PATTERN
CHECKER
Figure 4-5
076R160-000
Issue 4
Tx DRIVER
F
R
A
M
E
R
ANALOG
RECEIVER
End-to-End Self Test
SpectraComm 800 T3 Data Service Unit
Installation and Operation Manual
Diagnostics Overview
REMOTE SC800 T3 DSU
T
Tx DRIVER
3
F
N
R
E
A
T
M
W
E
R
O
R
ANALOG
K
RECEIVER
TEST
PATTERN
CHECKER
DTE
INTERFACE
TEST
PATTERN
GENERATOR
4-5