/engines/engine-2-1/directors:
Name
------------- -----------------
------------- -----------------
director-2-1-A 0x000000003ca00183 2
director-2-1-B 0x000000003cb00183 2
/engines/engine-2-2/directors:
Name
------------- -----------------
------------- -----------------
director-2-2-A 0x000000003ca00165 2
director-2-2-B 0x000000003cb00165 2
Task 27: Verify the
cluster status
Task 28: Expose
storage to hosts
Output example in a dual-engine cluster:
Director ID
Director ID
2.
VPlexcli-2
From the VPlexcli prompt on management server 2, type the
following command, and verify that all directors in cluster 1 appear in the output:
ll /engines/engine-1-*/**/directors
1.
VPlexcli-1
From the VPlexcli prompt on management server 1, type the
following command to display the cluster status:
cluster status
In the output, confirm that operational-status is ok and that there are no health
indications.
2.
VPlexcli-1
Type the following command to display a cluster summary:
cluster summary
In the output, verify that both clusters have the same Island ID and an operational
status of ok.
Use a VPlexcli session or the VPLEX Management Console GUI to perform this task.
Recommendations:
If a storage volume is equal to or larger than the desired virtual volume capacity,
◆
create an extent the size of the desired virtual volume.
If a storage volume is smaller than the desired virtual volume capacity, create a
◆
single extent per storage volume, and then use devices to concatenate or stripe
these extents into a larger device.
Create one view for each set of hosts that require access to the same storage.
◆
You can use the VPlexcli or the Management Console GUI to expose storage. The
basic steps are the same for either:
To use the GUI, proceed to
◆
To use the VPlexcli, proceed to
◆
Cluster Commissioned Operational Communication
ID
------------ Status
------- ------------ ----------- ------------
true
true
Cluster Commissioned Operational Communication
ID
------------ Status
------- ------------ ----------- ------------
true
true
"If you are using the GUI."
"If you are using the VPlexcli" on page
Setting up a VPLEX Metro implementation
Setting up VPLEX
Status
ok
ok
ok
ok
Status
ok
ok
ok
ok
72.
71