Setting Up A Vplex Local Implementation; Task 1: Set The Management Server's Public Ip Address; Laptop Connection To Management Server - EMC VPLEX Installation And Setup Manual

Setting up a VPLEX Local implementation

!
Task 1: Set the
management
server's public IP
address
Figure 20
CAUTION
If you are setting up a VPLEX Metro implementation, follow the tasks in
up a VPLEX Metro implementation" on page
individually and then join them later.
Before you can log in to the VPLEX management server over the customer network,
you must set the address on the management server's public Ethernet port:
Note: The tasks in this document use PuTTY for logging in to the management server.
However, you can use any similar Telnet/SSH client.
1. Connect your laptop to the management server as shown in
red service cable that hangs inside the EMC cabinet.
Ethernet port
Laptop

Laptop connection to management server

2. On your laptop's toolbar, select Start > Settings > Control Panel > Network
Connections (double-click).
3. If any public network connection is enabled on your laptop, right-click the
network card and select Disable.
4. On the Network Connections window, right-click Local Area Connection and
select Properties.
5. On the Local Area Connection Properties window, double-click Internet
Protocol (TCP/IP) under This connection uses the following items.
6. On the Internet Protocol (TCP/IP) Properties window:
a. If your laptop is configured with specific addresses, make a note of them, to
ensure that you reset the configuration correctly later.
b. Select Use the following IP addresses, and type the following values:
– IP address:
– Subnet mask:
– Default gateway: 128.221.252.2
7. Click OK on the Internet Protocol (TCP/IP) Properties window, and again on the
Local Area Connection Properties window.
8. Close the Network Connections window.
46. You cannot set up each cluster
Red service cable in cabinet
128.221.252.3
255.255.255.224
Setting up a VPLEX Local implementation
Setting up VPLEX
"Setting
Figure 20, using the
zep-009b
33