Putty Settings For Vplex_Service Session - EMC VPLEX Installation And Setup Manual

7. Click OK on the Internet Protocol (TCP/IP) Properties window, and again on the
Local Area Connection Properties window.
8. Close the Network Connections window.
9. Open a Command Prompt window (Start > Programs > Accessories > Command
Prompt), and type the following command to confirm the settings:
ipconfig
Output example:
Ethernet adapter Local Area Connection:
Connection-specific DNS Suffix
IP Address. . . . . . . . . . . . : 128.221.252.3
Subnet Mask . . . . . . . . . . . : 255.255.255.224
Default Gateway . . . . . . . . . : 128.221.252.2
10. Type the following command to verify that you can reach the management
server's service port:
ping 128.221.252.2
11. On your laptop, launch PuTTY.exe.
Note: If you see a PuTTY security alert, read it, and then click yes.
12. Configure the PuTTY Configuration window as shown in

PuTTY settings for VPLEX_service session

Figure 31
13. Select SSH in the Category list, and ensure that Preferred SSH protocol version
is set to 2, as shown in
. : eng.emc.com
Figure 32.
Setting up a VPLEX Metro implementation
Setting up VPLEX
Figure 31.
Type:
128.221.252.2
(default)
Type session name:
VPLEX_service
(default)
PuTTY
47