Task 9: Launch The Vplex Ez-Setup Wizard On Cluster 2 - EMC VPLEX Installation And Setup Manual

Setting up VPLEX
Figure 48
Task 9: Launch the
VPLEX EZ-Setup
Wizard on cluster 2
64 EMC VPLEX with GeoSynchrony 4.1 Installation and Setup Guide
Note: Over the course of setting up a dual-engine or quad-engine cluster, the log file can
grow quite large.
Note: The log file saves data from the current PuTTY session. Any time you open a new
session, you must repeat this step if you want to log the output for that session.
PuTTY Configuration: Logging window
29. Select Session in the Category list, and click Save in the PuTTY Configuration
window to save the settings for the session you configured.
30. Click Open, and log in to the management server with username service and
password Mi@Dim7T.
31. Type the following command to connect to the VPlexcli:
vplexcli
Log in with username service and password Mi@Dim7T.
The EZ-Setup Wizard performs several tasks to set up a VPLEX implementation,
based on a series of prompts for user-entered information. Refer to the EMC VPLEX
Pre-installation Configuration Worksheet as you respond to the prompts.
From the VPlexcli prompt, type the following command, and follow the steps in the
automated interview and configuration procedure:
configuration system-setup
Note: At any time, you can exit EZ Setup by typing the following command:
exit
To resume the setup, type the following command:
configuration system-setup
When you resume EZ Setup, the wizard returns to the first step. However, any values
you already entered now appear as the new default values.
All session output
File name
putty_log