Laptop Connection To Management Server - EMC VPLEX Installation And Setup Manual

Setting up VPLEX
Figure 40
58 EMC VPLEX with GeoSynchrony 4.1 Installation and Setup Guide
Ethernet port
Laptop

Laptop connection to management server

3. On your laptop's toolbar, select Start > Settings > Control Panel > Network
Connections (double-click).
4. If any public network connection is enabled on your laptop, right-click the
network card and select Disable.
5. On the Network Connections window, right-click Local Area Connection and
select Properties.
6. On the Local Area Connection Properties window, double-click Internet
Protocol (TCP/IP) under This connection uses the following items.
7. On the Internet Protocol (TCP/IP) Properties window:
a. If your laptop is configured with specific addresses, make a note of them, to
ensure that you reset the configuration correctly later.
b. Select Use the following IP addresses, and type the following values:
– IP address:
– Subnet mask:
– Default gateway: 128.221.252.2
8. Click OK on the Internet Protocol (TCP/IP) Properties window, and again on the
Local Area Connection Properties window.
9. Close the Network Connections window.
10. Open a Command Prompt window (Start > Programs > Accessories > Command
Prompt), and type the following command to confirm the settings:
ipconfig
Output example:
Ethernet adapter Local Area Connection:
Connection-specific DNS Suffix
IP Address. . . . . . . . . . . . : 128.221.252.3
Subnet Mask . . . . . . . . . . . : 255.255.255.224
Default Gateway . . . . . . . . . : 128.221.252.2
11. Type the following command to verify that you can reach the management
server's service port:
ping 128.221.252.2
12. On your laptop, launch PuTTY.exe.
Note: If you see a PuTTY security alert, read it, and then click yes.
Red service cable in cabinet
128.221.252.3
255.255.255.224
. : eng.emc.com
zep-009b