Rtu Communication Settings - Mitsubishi Electric Super-S ME96SS Series Manual

(2) In the case of using with VT
eVT/Direct voltage
<Secondary voltage settings>
DISPLAY SET
<Set primary voltage>
Can be set in 60~750,000V range (setting unit: V)
rCT current rSet CT.
Set the primary and secondary currents of the CT to be combined.
<Set secondary current>
<Set primary current>
DISPLAY SET
Can be set in1.0~30,000.0A range (setting unit: A)
tSet frequency.
tFrequency
Notes1. Frequency scale on bar graph display will also change.
Notes2. Analog output scale will also change.
DISPLAY SET
yRolling demand time ySet the rolling demand interval time limit
limit (1) Interval time limit
(2) Sub-interval time limit
DISPLAY SET
uDemand current time
uSet the demand current time limit.
limit
SET
Set-up menu
Select another set-up menu or finish set-up.
‡To continue to set-up
Select the menu No.
using the
Set-up menu 2: MODBUS
(when ME4210-SS96, ME0052-SS96 or ME0000BU-SS96 is installed and any options are not installed)
* Only in the case of ME96SSHA-MB or ME96SSRA-MB, it is applicable.
Set-up menu
Adjust the set-up menu No. to "2".
DISPLAY SET
RTU
qMODBUS ®
qSet MODBUS
communication address
Possible address settings: 1~255
DISPLAY SET
wSet the MODBUS
wMODBUS ® RTU
communication address
DISPLAY SET
(a) Three phase 4-wire setting (phase voltage)
63.5V 100V 110V
(b) Three phase 3-wire (2CT, 3CT) or Single phase 2-wire setting (line voltage)
100V 110V 220V
Under 100V: Top two digits settings
Over 100V: Top three digits settings
1A 5A
Under 10A: Top two digits settings
Over 10A: Top three digits settings
50Hz 60Hz
(Only ME96SSHA-MB and
Setting range Setting interval
1 ~ 15 ~ 60 (min) 1min
Setting range Setting interval
1 ~ 60 (min) 1min
0 s 40 s 3 min 7 min
10 s 50 s 4 min 8 min
20 s 1 min 5 min 9 min
30 s 2 min 6 min 10 min
or button.

RTU Communication settings

®
RTU communication address
®
RTU communication baud rate.
®
2400bps
4800bps
9600bps
19.2kbps
38.4kbps
115V 120V
Factory default settings
Three phase 4-wire: 200V (phase voltage)
Three phase 3-wire; Single phase 2-wire: 10,000V (line voltage)
Factory default setting: 5.0A
ME96SSRA-MB).
15 min
20 min
25 min
30 min
‡To finish set-up
Press the or button
to display the End screen,
then press the button
SET
to save the settings.
q
e(2)
r
t
y
u
w
16