Safety Information - ABB ACX Commissioning Instruction

Safety Information

Important Safety Information
Intended Conditions of
Use
Requirements for Safe
Operation
Personnel
Qualifications
Special Information and
Precautions
Safety Labels Affixed to
the Analyzer System
National Regulations
Analyzer System Safety
and Safe Operation
CI/ACX-EN Rev. D
The analyzer system is designed for continuous measurement of concentrations of
specific components in gases or vapor. Any other application is not compliant with the
specified use. Observation of this manual is also part of the specified use.
The analyzer system must not be used to measure flammable gases or combustible
gas/air or gas/oxygen mixtures. The analyzer system must not be installed in
hazardous locations.
The analyzer system interior remains free of explosive atmosphere during normal
operation. Therefore, the integration of explosion protection measures inside the
analyzer system is not required.
In order to operate in a safe and efficient manner, the analyzer system should be
properly handled and stored, correctly installed and set-up, properly operated and
carefully maintained.
Only persons familiar with the installation, set-up, operation and maintenance of
comparable analyzer systems and certified as being capable of such work should work
on the system.
These include
•
The content of this manual,
•
The safety labels affixed to the analyzer system,
•
The applicable safety precautions for installing and operating electrical devices,
•
Safety precautions for working with gases, acids, condensates, etc.
Observe the safety labels affixed to the analyzer system or to the individual
components:
Consult Documentation!
Corrosive Material!
The regulations, standards and guidelines cited in this operator's manual are
applicable in the Federal Republic of Germany. The applicable national regulations
should be followed when the analyzer system is used in other countries.
The analyzer system is designed and tested in accordance with EN 61010 Part 1/
IEC 1010-1, "Safety Provisions for Electrical Measuring, Control, Regulation and
Laboratory Instruments" and has been shipped ready for safe operation.
To maintain this condition and to assure safe operation, read and follow the safety
information identified with the safety symbols in this manual. Failure to do so can put
persons at risk and can damage the analyzer system as well as other systems and
instruments.
ACX Analyzer System Commissioning Instruction
Hot Surface! (Temperature > 60 °C)
Risk of Electric Shock!
7