ABB ACX Commissioning Instruction page 46

Adjustment of Cycle Time and Post-Purge Time
Adjustment of Cycle
Time and Post-Purge
Time
Procedure
46
To adjust the cycle time or post-purge time you must change the parameters of
function blocks.
WARNING!
Only changes as described below may executed! Changes of function block
parameters inappropriately executed may affect the complete function of the
function blocks program!
Step Action
1 Push Softkey
The window
2 Select menu
The window
3 Select menu
The window
4 Select menu
The window
To adjust the cycle time:
5 Select timer
The window
of this function block.
6 Select the parameter
The window
already active.
7 Enter the password, using the numeric keys. The factory-set password is
325465.
The window
Cycle time
parameter
8 Change the shown value (factory-set = 4 hrs) to the new value required.
9 Return to normal measuring operation using the key MEAS.
To adjust the post-purge time:
5 Select timer
The window
of this function block.
6 Select the parameter
The window
already active.
7 Enter the password, using the numeric keys. The factory-set password is
325465.
The window
Low time
parameter
8 Change the shown value (factory-set = 150 sec) to the new value required.
9 Return to normal measuring operation using the key MEAS.
ACX Analyzer System Commissioning Instruction
MENU
.
MAIN MENU
is shown.
Configure
.
CONFIG:
is displayed.
Functions blocks
.
CONFIG: FUNCTION BLOCK
Miscellaneous
and after this menu
CONFIG.: TIMER
is displayed.
Zycl.
.
CONFIG: TIMER CYCL.
Low time
.
PASSWORD ENTRY
is shown, if the password is not
CONFIG: TIMER CYCL.
is shown.
DELAY
.
CONFIG: TIMER DELAY
Low time
.
PASSWORD ENTRY
is shown, if the password is not
CONFIG: TIMER DELAY
is shown.
is displayed.
Timer
.
is shown with the parameters
with indication of the
is shown with the parameters
with indication of the
CI/ACX-EN Rev. D