ABB ACX Commissioning Instruction page 51

AO2000-Fidas24: Connecting the Sample Gas Line
Sample Gas Line
Connection
Fittings and O-Rings
Figure 10
Sample Gas Line
Connection on AO2000-
Fidas24 Heated Sample
Gas Port
CI/ACX-EN Rev. D
CAUTION!
Before start-up of the gas analyzer it is imperative to remove any plastic sealing
stopper inserted in the sample gas inlet at the factory.
Connect the heated sample gas line directly to the sample gas inlet of the AO2000-
Fidas24 VOC analyzer (see Figure 10). Make sure that the O-rings are properly seated
and the sample gas line is fully inserted in the sample gas port.
The required fittings and O-rings are supplied in the accessory kit.
1
Heated Sample Gas Line (tube with 4/6-mm ID/OD)
2
O-Ring 6.02 x 2.62
3
Fitting
4
O-Ring 12.42 x 1.78
ACX Analyzer System Commissioning Instruction
4 3 2 1
51